Surelink statistics – Digi X2 User Manual

Page 187

Advertising
background image

1 8 7

M o n i t o r a n d m a n a g e D i g i d e v i c e s

SureLink statistics

Digi SureLink™ provides an “always-on” mobile network connection to ensure that a

Digi device is in a state where it can connect to the network.

The statistics displayed for Digi SureLink pertain to the periodic tests, known as Link

Integrity Monitoring tests, that are run over the established PPP connection to ensure that

end-to-end communication is possible. There are three Link Integrity Monitoring tests

available: Ping Test, TCP Connection Test, and DNS Lookup Test. For descriptions of

these tests, see "Link integrity monitoring settings" on page 126.

In these SureLink statistics, a “session” is a PPP session. The session statistics are reset to

zero at the start of a new PPP connection. The “total” statistics are the accumulated totals

for all sessions since the device booted. The “tests” are the SureLink Link Integrity

Monitoring tests that have been configured to be run when the mobile network connection

is established.

session successes

The number of times a configured test was attempted and succeeded in the current PPP

session.

session failures

The number of times a configured test was attempted but failed in the current PPP

session.

session consecutive failures

The number of consecutive failures for a test, with no success. When a test is successful,

the consecutive failures counter is reset to zero. The consecutive failures counter

indicates a device's “progress” toward the configured maximum number of consecutive

failures, after which the PPP link is taken down (and restarted).

session bypasses

If a configuration parameter is bad, a test is bypassed rather than considered to have

succeeded or failed. This means the test was not run. If the PPP connection goes down

while a test is in progress, that test may be classified as bypassed, since it could not be

run. (Note that the PPP link may come down for many reasons, independent of

SureLink testing.)

total successes

The total number of times a configured test was attempted and succeeded since the Digi

device was booted.

Advertising