Digi X2 - Manual (Page 221)

2 2 1
S p e c i f i c a t i o n s a n d c e r t i f i c a t i o n s
Regulatory information and certifications
Safety standards
The ConnectPort X8 gateway device complies with the standards cited in this section.
FCC Part 15 Class B
Radio Frequency Interface (RFI) (FCC 15.105)
The ConnectPort X8 gateway device has been tested and found to comply with the limits
for Class B digital devices pursuant to Part 15 Subpart B, of the FCC rules. These limits
are designed to provide reasonable protection against harmful interference in a residential
environment. This equipment generates, uses, and can radiate radio frequency energy, and
if not installed and used in accordance with the instruction manual, may cause harmful
interference to radio communications. However, there is no guarantee that interference
will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try and correct the interference by one or
more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which
the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
Labeling Requirements (FCC 15.19)
This device complies with Part 15 of FCC rules. Operation is subject to the following two
conditions: (1) this device may not cause harmful interference, and (2) this device must
accept any interference received, including interference that may cause undesired
operation.
If the FCC ID is not visible when installed inside another device, then the outside of the
device into which the module is installed must also display a label referring to the