Using the reset button – Digi X2 User Manual
Page 216
Advertising
A d m i n i s t r a t i o n f r o m t h e w e b i n t e r f a c e
2 1 6
Using the Reset button
If the Digi device cannot be accessed from the web interface, the configuration can be
restored to factory defaults by using the Reset button.
1
Power off the Digi device by unplugging the power supply.
2
Press the Reset button gently (shown in the illustration below) with a non-
conducive, small diameter tool (such as wood or plastic) with a blunt end (NOT
SHARP or the button could be damaged) to hold down the Reset button.
3
Power on the device while holding the rest switch down (about 20 -40 seconds.)
4
The status LED should blink in a 1-5-1 pattern.
5
Release the Reset button. The device should be at factory default settings.
WAN
RESET
Advertising