Display Devices Lifts up up 35 lbs - Manual (Page 12)

IP025-001 V3
IBL Lift Series Installation
07/05 Thor/Sales Info/Installation Materials/IBL Lift 12
Caution!
Make sure all tools, cables, and body parts are clear of the lift before pushing
the UP button.
10.) With the hand-held remote control, press the UP button to send the lift to its
fully UP, home position. Refer to the Remote Control Operation and Programming
section for details on how to operate program the lift’s functions.
For this installation, here is a guide to the LEDs on the control box and the remote, and
what the blinking means:
If the LED…
It means… Fix it by…
Is Continuously On The NO MOVEMENT switch on
the side of the control box is
activated. This disables all
movement of the lift. Moving the switch to the OFF
position
Blinks twice (after unit is
powered up, LED then stops
blinking) The lift is operational
Blinks three times NA NA
Blinks four times Motor is not moving Check the power to the motor
or for a mechanical
obstruction on the lift
Blinks five times Low AV line voltage Check circuit voltage
Blinks six times Cables off the drum Re-cable the drum(s)
Blinks seven times Lower limit safety switch
activated Follow steps on page 25 of
the remote instructions
Circuit
Breaker
Remote
Control
Input Ports
12VDC Out
No Movement Switch
AC Configuration
DIP Switches
12VDC In
Main Power Switch
AC Input
AC Trigger