Display Devices Lifts up up 35 lbs User Manual
Page 13
IP025-001 V3
IBL Lift Series Installation
07/05
Thor/Sales Info/Installation Materials/IBL Lift
13
Projector Mounting
1.)
The lift is shipped with the projector mounting adapter attached. Remove it from
the lower frame of the lift, if you have not already done so.
2.)
Invert your projector and attach the mounting adapter to the bottom of the
projector with the proper hardware.
3.)
Find the projector’s center of gravity using a dowel.
4.) Attach
the
adapter to the lift with the projector’s center of gravity under the
vertical wire rope of the lift. Use the enclosed ¼”-20 hardware.
Cabling the Lift
The IBL Series lifts accommodates a limited number of cables. We recommend
Extron
TM
Superflex Mini HR cable.
Caution
:
Using large diameter RGB and other
signal and / or control cable is not recommended on Display Devices lifts.
Large, bulky cables have too large of a bend radius to allow them to fit in the cable
management clips mounted on the scissor assembly.