Display Devices Lifts up up 35 lbs - Manual (Page 19)

IP025-001 V3
IBL Lift Series Installation
07/05 Thor/Sales Info/Installation Materials/IBL Lift 19
Emergency Operation
If your lift has traveled below the service position, and activated the lower limit safety
switch, you will need to refer to the Remote Control Operation and Programming
section and/or follow the steps below:
1. Remove the back cover of the handheld remote control case, or remove the
switch plate from the wall box.
2. Press and hold the EMERGENCY button in the circuit board, press the UP
button and release, then release the EMERGENCY button. The Lift should travel
upward.
3. Verify operation and reprogram positions if necessary.
If the above steps do not resolve the problem, call Technical Support at 303.412.0399
during normal business hours, or E-mail Display Devices, Inc. at
[email protected] .
Front Back
UP
DOWN
STOP
EMERGENCY – accessible only
with back cover removed
SET
These two bottoms are accessed with a small point
OVERRIDE