EXFO IQS-8100 Series Transport Blazer for IQS-600 - Manual (Page 25)

SONET/SDH Application 11
3 Getting Started
If the IQS-8100 Series Transport Blazer has been purchased at the same
time as the IQS-600, the IQS-8100 Series module is pre-installed with the
appropriate IQS Manager software version.
IQS Manager Installation
The IQS Manager is the baseline software and thus needs to be installed on
the IQS-600 before using the IQS-8100 Series module.
Note: Refer to the IQS-600 platform user guide for more information on IQS
Manager installation procedure.
Inserting and Removing Test Modules
Note: Refer to the IQS-600 platform user guide for more information on how to
insert a module into the IQS-600 or to remove a module from the IQS-600.
For IQS-8140, use respectively the retaining screw number 2, 3, or 4 (from
bottom to top) depending if the module is inserted in slots 0 to 5, 1 to 6, or 2
to 7.
Turning the Unit On
Turn on the IQS-600. Refer to the IQS-600 platform user guide for more
information.
C
AUTION
Never insert or remove a module while the controller unit and its
expansion units are turned on. This will result in immediate and
irreparable damage to both the module and unit.