EXFO IQS-8100 Series Transport Blazer for IQS-600 - Manual (Page 95)

Creating and Starting a Test Case
SONET/SDH Application 81
Typical Test Cases
4. Select the test
path/mapping.
4a. From the data path
selector, press the
desired
path/mapping.
Choices depend on
the selected
interface. See
Supported
Paths/Mappings on
page 59 for more
information.
4b. Press a timeslot from the Grid tab when applicable.
4c. For STS/STM and VT/AU mapping level, select
the Enable TCM check box if needed.
4d. For DSn/PDH mapping level,
select the Framing. For more
information, refer to DSn Tabs or
PDH Tabs.
For DS3, select the Enable FEAC
check box to allow far end alarm and control testing.
For DS1, select the Enable FDL check box to allow facility data
link testing.
For DS1/E1, select the Enable DS0/E0 check box to allow DS0 or
E0 testing.
4e. For Pattern, go to step 5.
4f. Press Next or Finish.
4g. Repeat step 4 as required to complete the path/mapping. See
Supported Paths/Mappings on page 59 for more information.