Electrical sonet/dsn/sdh/pdh interface connection – EXFO IQS-8100 Series Transport Blazer for IQS-600 User Manual
Page 36

Physical Interfaces and LEDs
22
IQS-8100 Series Transport Blazer
Electrical SONET/DSn/SDH/PDH Interface Connection
Electrical SONET/DSn/SDH/PDH Interface
Connection
³
2M/8M/34M/45M/52M/140M/155M port: The IQS-8105/15/20/30
provides two BNC connectors, labeled 2M-155M or
2M/8M/34M/45M/52M/140M/155M IN and OUT, for E1/2M, E2/8M,
E3/34M, DS3/45M, STS-1e/STM-0e/52M, E4/140M, STS-3e/STM-1e/155M
testing capability. Connector type is BNC for coaxial 75-ohm cable
connection.
³
1.5M/2M Bantam port: The IQS-8105/15/20/30 provides an IN/OUT
Bantam connectors for DS1/1.5M and E1/2M testing capability.
³
1.5M/2M RJ-48C port: The IQS-8105/15/20/30 provides an IN/OUT
RJ-48C connectors for DS1/1.5M and E1/2M testing capability.
Note: Dual RX test case uses the BNC labelled AUX as the second RX port.
Connect the signal to be tested to the corresponding port.