FeiYu Tech Panda Autopilot - Manual (Page 21)

Guilin Feiyu Electronic Technology Co., Ltd
Guilin Feiyu Electronic Technology Co., Ltd http://www.feiyudz.cn [email protected]
Page 20
OPTION 3: TWO RECEIVER SYSTEM
a) Option 3 is the combination of Option 1 and Option 2.
b) In Option 3, you will require two receivers of the same frequency.
c) Ensure that both receivers can be controlled by your RC transmitter.
d) One receiver is installed on board the aircraft (as per Option 2), while the other receiver
is installed at the Ground Station (as per Option 1).
e) The Channel utilization on both the on-board receiver and Ground Station receiver must
be the same.
f) The receivers must be at least 6 channels.
g) Two of the channels require a three-position switch (e.g. Channel 5 and 6).
h) Since both systems can be used to control your aircraft, the maximum flight range is
either your RC Transmitter or the Data Radio, whichever can reach further out.But it
depend on you activated which receiver via the GCS button(―Receiver control ‖ or
―DRRC‖)
i) e.g. If your RC Transmitter is out of range, while Data Radio is still within range, and
you select ―DRRC‖ then the Data Radio can still fly the plane via the planned GCS flight
route. But if you select ―Receiver control‖ then the distance due to the RC transmitter.
USB—Serial TTL
Data radio
NOTE: If you wish to use a 5 volt
Receiver battery to power the ground
station system, please disconnect the 5
volt power coming from the USB
Interface cable.