FeiYu Tech Panda Autopilot - Manual (Page 48)

Guilin Feiyu Electronic Technology Co., Ltd
Guilin Feiyu Electronic Technology Co., Ltd http://www.feiyudz.cn [email protected]
Page 47
6. Ensure that the pitch and roll indicators are moving properly and do not deviate.
7. During this throttle increment tests, observe your GCS Screen (above).
8. If the ―Attitude error" sign is activated as shown above, that means the system is
experiencing excessive vibration and the autopilot cannot function properly.
9. Attitude error corresponds to 1000 attitude errors during the test process.
10. Check your installation. Provide additional vibration damping if necessary and restart the
test from the beginning.
The Functions Describe
Auto Photo: the button will turn green when turn on. Autopilot takes photos automatically
according to the setting distance or time interval.
Photo: it will take a picture when click the button. Photo interfaces are controlled by I/O level,
you can select high or low level by setting photo reverse. I/O level can be used to drive the relay,
or control the camera which supports level control directly.
Repeat Path: if setting the navigation path, the plane will not entrance circling mode, while
repeat flies according the setting waypoint. But if you carry out the repeat path after entrancing
circling mode, the plane will not enter repeat flies mode, so you have to switch to auto
navigation mode, then cut in airline operation. Only by this can you carry out this function.
Parachute: click the button to open the umbrella.
Parameter setting
Target Speed: Set the flight cruising speed.
Target Height: Set the current altitude when fixed high flight. You can change the altitude of
fixed high flight when real time set the value.
Circle Radius: Set the circling radius.
Photo Interval: Set the photo interval of auto photo time or distance.
Throttle Hold: Set the throttle control neutral value. This value will be got automatically when
enter automatic mode. You do not need to set.
Photo Taking: Set the time interval from press the camera shutter to make photographs.
Note : if it is the oil machine, you have to check the working stability of motor. Make sure that
the engine not shut down when fast control throttle servo. Here you should set the throttle hold
value.