FeiYu Tech Panda Autopilot - Manual (Page 34)

Guilin Feiyu Electronic Technology Co., Ltd
Guilin Feiyu Electronic Technology Co., Ltd http://www.feiyudz.cn [email protected]
Page 33
Flight Parameter Setting:
1、TGT SPD: Target ground speed setting in kilometers per hour (km/h).
2、TGT ALT: Target altitude setting in meters (m).
3、Circle radius: Circling radius setting in meters (m).
4、Photo interval: Set automatic photography interval for photo‘s along flight path in meter
(m).or for photo‘s along time in second(s).
5、Throttle hold: Set throttle hold.
6、Photo taking: Set the time interval from active shutter to generate photos.
PID para:
1. Set: Sets the parameter of each flight control gain.
2. Save to AP: Save the setting parameters to Autopilot permanently.
3. Read: Read the parameter.
Flight para:
1. Set: Sets the parameter of each flight control gain.
2. Mix control: Sets up the mixed control mode of the autopilot. This adapts controls for
elevons, ailerons, rudder etc.
3. REV rudder settings: Set up the servo and throttle control direction.
4. Check Gyro: Gyro testing to see if it works OK.
5. Gyro init: Gyro initialization.
6. Servo neutral: Record servo neutral when in Level flight.
Other settings:
1.
I nstallation Settings: set the install direction of the autopilot (relative to the nose of the
plane). There are four directions, forwards, back, left, right.
2. Time mode: Set the taking photo mode is time interal trigger. E.g. each 5second take one
photo.
3. Distance mode: Set the taking photo mode is distance interal trigger. E.g. each 100m take
one photo.
METER BAR DISPLAY
a) The meter bar provides a graphical aircraft instrument display area.
b) The instrument panel is divided into some sections as shown below:
At the top of the meter bar are the gradienter and course compass, can real-time display
the current attitude and the heading of the plane.
At the bottom of meter bar, there are GPS lock info, voltage, battery power consumed,
Pulse width time of the servo output, target point info, communication data info, and
other data info, etc.