Glow-worm Clearly Hybrid - Back-up Module System - Manual (Page 32)

0020096317_01 - 08/10 - Glow-worm
- 30 -
INSTALLATION
12.9.3 System information
• Using the buttons ,
select System on the screen.
• Press the button to confirm.
This screen indicates:
- the external temperature,
- the heating circuit pressure.
• To access the information relative to
the components, press
and confirm with the button .
• Press the button to consult the
fault report.
• To reset the fault report, press
and confirm with the button
.
12.9.4 Information on heating zone
• Using the buttons ,
select Heating zone on the screen.
• Press the button to confirm.
This screen is only displayed if you
have installed more than one heating
zone.
• Select the zone you want to consult
using the buttons .
• Press the button to confirm.
This screen indicates:
- the heating circuit temperature setting,
- the temperature of the room in which
the room thermostat is located,
- whether the heating zones respond to
a demand (ON or OFF),
- the status of the 2-way valve (ON or
OFF).
12.9.5 Information about the domestic hot water
cylinder option
i This menu is only available if you have chosen the
domestic hot water tank option.
• Using the buttons ,
select DHW cylinder on the screen.
• Press the button to confirm.
This screen indicates:
- The set point of the DHW cylinder.
- whether the DHW cylinder respond to
a demand (ON or OFF),
- The status of the domestic hot water
tank valve (ON or OFF),
- The temperature of the hot water
measured by the tank sensor.
12.10 Options
• Using the buttons ,
select Parameters on the screen.
• Press the button to confirm.
This menu allows you to:
- change the language of the control
unit menus
- adjust the brightness and contrast of
the screen
- to display the versions of system’s
software.