Desa CGEFP33PRB - Manual (Page 24)

www.desatech.com 111245-01C 24
INSTALLING LOGS
WARNING: Failure to position
the parts in accordance with these
diagrams or failure to use only
parts specifically approved with
this heater may result in property
damage or personal injury.
CAUTION: Do not remove the
warning and instruction labels
attached to the heater base as-
sembly. These markings contain
important warranty information.
CAUTION: After installa-
tion and periodically thereafter,
check to ensure that no flame
comes in contact with any log.
With the heater set to HI, check
to see if flames contact any log. If
so, reposition logs according to
the log installation instructions
in this manual. Flames contact-
ing logs will create soot.
It is very important to install these logs exactly
as instructed. Do not modify logs. Only use logs
supplied with heater.
1. Locate pegs on the bottom of back log (#1).
Slide these pegs into the holes in the grate base
behind the burner (see Figure 41).
2. Place the base of the middle log (#2) in the
U-shaped slots of the grate base in front of the
back log. The cutout on the right of the middle
log should fit over the burner (see Figure 42).
Make sure the front of the middle log is resting
on the tabs of the grate base and the cutout area
is centered over the burner “U” bend.
3. Locate the notches in the bottom of the front
log (#3). Place the front log on the grate fingers.
Make sure the notches of the front log line up
with the grate fingers (see Figure 43).
4. Place left crossover log (#4) across logs #1, #2
and #3 fitting holes on bottom of log #4 onto pin
on front and middle logs as shown in Figure 44.
5. Place right crossover log (#5) in the same manner
on right side of logs (see Figure 44, page 25).
INSTALLATION
Continued
Figure 43 - Installing Front Log (#3)
[CGEFP Logs Shown]
Front Log (#3)
Grate
Fingers
Notches
Figure 42 - Installing Middle Log (#2)
[CGEFP Logs Shown]
Middle
Log (#3)
Cutout
Tab
Burner
"U" Bend
U-shaped
Slot
Figure 41 - Installing Back Log (#1)
[CGEFP Logs Shown]
Burner
Hole in
Grate Base
Back
Log (#3)