Vortech 2006-2010 6.1L Jeep SRT8 User Manual
Page 13
P/N: 4CK020-010 v6.0, 02/17/2012
©2012 Vortech Engineering, Inc
All Rights Reserved, Intl. Copr. Secured
3
A. Relieve the fuel system pressure
B. Disconnect the eight fuel injector plugs and
retaining clips from the injectors.
C. Remove the four screws that hold down the
fuel rail on the intake manifold. Lift up on the
rails evenly and remove all eight injectors.
D. Using a small amount of clean motor oil, light-
ly lubricate the O-rings on both ends of the
Vortech supplied fuel injectors. Install the fac-
tory injector retaining clips.
E. Install the new injectors into the fuel rails with
the terminals facing outward.
F. Carefully lower the fuel rail/injector assembly
down onto the intake manifold.
G. Check to see that each injector has been
seated properly into the intake manifold.
H. Re-install both driver side fuel rail bolts and
the front passenger side bolt. Set aside the
remaining bolt as it will be used in a later
step. Attach the injector plugs to the injectors.
3.
FUEL INJECTOR REPLACEMENT