Vortech 2006-2010 6.1L Jeep SRT8 - Manual (Page 42)

P/N: 4CK020-010 v6.0, 02/17/2012
©2012 Vortech Engineering, Inc.
All Rights Reserved, Intl. Copr. Secured 32
Fig. c
D. Open rear hatch door of vehicle to gain
access to FPB mounting location. Remove the
bottom plastic trim panel piece along bottom
edge at latch. Remove two 10mm nuts and lift
up subfloor to gain access to FPB mounting
location.
E. Place FPB in the mounting location lowering
subfloor to confirm location and fit. Mark
mounting location and cut away insulation
mat. (See Fig. c)
F. Position the FPB unit as shown in Fig. 10-d
and mark the three mounting holes for drilling.
G. Using a drill with a 9/64” drill, drill 3 mounting
holes.
H. Mount the FPB unit to the floor using the three
#10 sheet metal Phillips head screws. (See
Fig. e)
Fig. e
Fig. d