Vortech 2006-2010 6.1L Jeep SRT8 - Manual (Page 18)

P/N: 4CK020-010 v6.0, 02/17/2012
©2012 Vortech Engineering, Inc.
All Rights Reserved, Intl. Copr. Secured 8
1. Install a 1” long piece of the supplied ¾” hose
over the end of the passenger side fuel rail
(See Fig. 7A-a).
2. Using pipe thread sealant, install two 1/2"
NPT X 3/4" barbed straight fittings into the
upper and lower holes on the CAC end tank.
3. Install the supplied grommet into the hole in
the CAC discharge tank, install IAT sensor,
and plug it in.
4. Lower the CAC into place over the passenger
side valve cover and loosely attach it to the
supercharger and throttle body using the sup-
plied silicone elbows. Using the 2.75 90°
elbow, connect the short leg to the super-
charger discharge and the other end to the
left air tank on the CAC. Connect the 2.75-
inch end of the 180° silicone hose to the right
air tank on the CAC and the 3.5-inch end to
the throttle body. Install the bypass valve
using a gasket and the supplied hardware.
7.A CHARGE AIR COOLER (CAC) INSTALLATION
Fig. 7A-a
Fig. 7A-b
Fig. 7A-c