Vortech 2006-2010 6.1L Jeep SRT8 - Manual (Page 23)

P/N: 4CK020-010 v6.0, 02/17/2012
©2012 Vortech Engineering, Inc
All Rights Reserved, Intl. Copr. Secured 13
A. Using pipe thread sealants, thread the two
1/4 NPT to 3/8 barb fittings in either end of
the map sensor block and the 1/16 barb fitting
in appropriate hole.
B. Assemble the supplied MAP sensor and MAP
sensor bracket into the block using 10-24
screws. Unplug the factory MAP sensor and
plug in the supplied MAP sensor. Factory
MAP sensor is located at the back of the
intake manifold and is most easily removed
from the driver side.
C. Attach map sensor assembly to the top of the
rear passenger side fuel rail mount.
D. Remove the 3/8” vacuum line from the brake
booster fitting. Re-route the hose towards the
passenger side of the motor and connect the
line to the rear facing fitting on the map sen-
sor. Connect the other fitting on the MAP sen-
sor block back to the brake booster using the
supplied 3/8” rubber hose. Install a supplied
hose clamp on each connection.
E. Connect 5/32” vacuum line from the bypass
valve to the map sensor block fitting.
F. Tighten clamps on the supplied Ø2.75” 90º
elbow that attaches the supercharger dis-
charge to the CAC.
G. Tighten clamps on the supplied Ø2 ¾” to 3 ½”
180º elbow that attaches the CAC to the
throttle body (see Fig. 8-b for reference).
H. It may be necessary to trim the vehicles plas-
tic radiator shroud to provide proper clear-
ance for the 180º silicone elbow.
8. SUPERCHARGER DISCHARGE ASSEMBLY INSTALLATION
Fig. 8-a
Fig. 8-b