Vortech 2006-2010 6.1L Jeep SRT8 User Manual
Page 17
P/N: 4CK020-010 v6.0, 02/17/2012
©2012 Vortech Engineering, Inc
All Rights Reserved, Intl. Copr. Secured
7
A. Remove the upper radiator hose from the
thermostat housing.
B. While the upper radiator hose is detached,
rotate the two hose clamps on the short sec-
tion so that they are pointed away from the
drive assembly and bracket (See Fig. 6-a).
C. Relocate upper A/C line to reside above radi-
ator hose by first releasing it from support on
front of water pump and then routing the
upper radiator hose below it before re-attach-
ment to the thermostat housing (See Fig. 6-b,
6-c).
D. Re-install the upper coolant hose if removed.
E. Remove coolant “bleed” plug.
F. Re-fill coolant system remembering to plug
the “bleed” as soon as coolant comes out of
it.
G. Using the supplied 5/16” rubber line, route
radiator overflow tube around supercharger
and away from the blower drive pulley.
6.
ENGINE COOLANT HOSE MODIFICATION
Fig. 6-a
Fig. 6-b
Fig. 6-c
Fig. 6-d
BLEED PLUG
ROTATE THESE
CLAMPS UP AS
SHOWN
REROUTE A/C LINE
ABOVE RADIATOR
HOSE
NOTE: Rotation of the rubber coolant hose and elbow may be
required for adequate clearance to the drive belt and
assembly. Double check that hose clearance is ade-
quate after clamps have been secured..