Vortech 2006-2010 6.1L Jeep SRT8 - Manual (Page 43)

P/N: 4CK020-010 v6.0, 02/17/2012
©2012 Vortech Engineering, Inc
All Rights Reserved, Intl. Copr. Secured 33
I. Locate the 1/8” nylon Instrument tubing, 10ga.
red wire, 12ga.orange wire, 14ga. red wire,
and install it into the 1/2” plastic split loom
making a harness assembly.
J. Locate the rubber plug shown in Fig. f and
Fig. g. Using a sharp knife or blade cut the
bottom out of the plug to provide through
access for ½” harness assembly.
K. From the underside of the vehicle route the
harness assembly up through the modified
plug to the FPB previously installed. Secure
the loom with provided tie wraps in Fig. f.
L. Locate the 11’ piece of 3/8” plastic split loom
and install the 1/8” nylon instrument tube and
red 10ga. power wire. Continue routing the
harness assembly loom (See Fig. h, Fig. i)
through the factory fuel line supports along the
inside of the underbody and secure with zip
ties as needed. Leave the 12ga. orange and
14ga. red wire hanging as shown in Fig. h to
be used in a later step.
Fig. g
Fig. f
Fig. i Fig. h