Vortech 2006-2010 6.1L Jeep SRT8 - Manual (Page 39)

P/N: 4CK020-010 v6.0, 02/17/2012
©2012 Vortech Engineering, Inc
All Rights Reserved, Intl. Copr. Secured 29
Fig. aw
AJ. Re-connect the factory electrical connector to
the underside of the fuel canister lid using
dielectric grease on the plug terminals.
AK. Onto the free end of the new fuel line slide a
stepless 17.0 clamp. Install fuel line to the barb
located on the middle section of the fuel canister
and tighten clamp (See Fig. as). Trim rubber
hose for best fit.
AL. Compress the lid down and make sure that the
fuel lines and wires will be free of kinks once the
canister is re-installed.
AM. Re-install the newly assembled fuel pump canis-
ter back into the tank using the original o-ring
gasket. Be sure to orient the unit so that the
locating tab lines up with the arrow and the fuel
connection points towards the appropriate side
of the tank. (See Fig. aw)
Fig. as