Vortech 2006-2010 6.1L Jeep SRT8 - Manual (Page 15)

P/N: 4CK020-010 v6.0, 02/17/2012
©2012 Vortech Engineering, Inc
All Rights Reserved, Intl. Copr. Secured 5
K. Loosely install the upper mounting bracket
support using two .45” long spacers as shown
in Fig. 4-f.
L. Tighten the fasteners that go all the way
through into the head first and then tighten
the rest.
M. Remove factory tensioner and replace with
the supplied replacement tensioner in your
kit.
N. Per Fig. 4-h, install the supplied .15" thick
spacer, one of the supplied aluminum idlers
(with snap ring facing rearward), and one of
the supplied .38" spacers onto the previously
installed 10mm alternator stud.
O. Install the lower mounting bracket support
over the three previously installed studs as
shown in Fig. 4-i.
P. Recheck and tighten all of the mounting
bracket hardware.
Q. Retract the belt tensioner and install the six
rib belt. Release belt tensioner.
Fig. 4-f
Fig. 4-i
LOWER MOUNTING
BRACKET SUPPORT
M10 STUD SHOWN OFF
VEHICLE FOR CLARITY
.15" SPACER (PILOT
POINTS FORWARD)
.38" SPACER (PILOT
POINTS REARWARD)
ALUMINUM IDLER (SNAP
RING SIDE FACES REAR OF
VEHICLE)
Fig. 4-h
Fig. 4-g
1.97" SPACERS
UPPER MOUNTING
BRACKET SUPPORT
.45" SPACERS
2.9" SPACER
Fig. 4-j