Vortech 2006-2010 6.1L Jeep SRT8 - Manual (Page 24)

P/N: 4CK020-010 v6.0, 02/17/2012
©2012 Vortech Engineering, Inc.
All Rights Reserved, Intl. Copr. Secured 14
A. Start by disconnecting the fuel supply and
fuel vapor lines located just in front of the fuel
tank. Disconnect by pushing connector for-
ward slightly, and then while depressing the
retainer clip tab as shown pull the connector
back and off the hard metal line.
(See Fig. a, Fig. b).
B. At the rear of the tank disconnect the two
lines that go to the fuel vapor canister ( white
connector and black connector with yellow
clip). Disconnect the fill tube from the tank by
loosening the clamp and separating the hose.
(See Fig. c, Fig. d)
Fig. a
NOTE: This section is easier when the tank is less than half full.
NOTE: Always use caution and use of safety goggles is rec-
ommended when disconnecting fuel lines that may be
under pressure. Fuel will escape from connection.
Take care to keep heat sources away.
Fig. b
9. FUEL PUMP INSTALLATION
Fig. d Fig. c