Uniden BCD396XT - Manual (Page 245)

245
Get/Set Group Information.
In set command, only "," parameters are not changed.
The set command is aborted if any format error is detected.
When the system protect bit is ON, except [NAME], [REV_INDEX], [FWD_INDEX],
[SYS_INDEX], [CHN_HEAD], [CHN_TAIL], other parameters will be send as a
reserve parameter in the Radio -> Controller command.
This command is only acceptable in Programming Mode.
<COMMAND ACC>
Append Channel / Trunk Frequency
Controller → Radio
ACC,[GRP_INDEX][\r]
Radio → Controller
ACC,[CHN_INDEX][\r]
[GRP_INDEX] : Channel Group Index
[CHN_INDEX] : Appended Channel Index
- or -
[GRP_INDEX] : Site Index
[CHN_INDEX] : Appended Trunk Frequency Index
Append Channel to the group. Or, append Trunk Frequency to the Site.
Returns "-1" if the scanner failed to create because of no resource.
This command is only acceptable in Programming Mode.
<COMMAND ACT>
Append TGID
Controller → Radio
ACT,[GRP_INDEX][\r]
Radio → Controller
ACT,[INDEX][\r]
[GRP_INDEX] : TGID Group Index
[TGID_INDEX] : appended TGID Index
Append TGID to the group.
Returns "-1" if the scanner failed to create because of no resource.
This command is only acceptable in Programming Mode.
<COMMAND DCH>
Delete Channel
Controller → Radio
DCH,[INDEX][\r]
Radio → Controller
DCH,OK[\r]
[INDEX] : Channel Index, TGID Index or Trunked Frequency Index
This command deletes a Channel and TGID.
This command is also valid for deleting a Trunk Frequency.
This command is only acceptable in Programming Mode.