Uniden BCD396XT - Manual (Page 97)

Friday, November 07, 2008 97
Set Delay Time
This setting controls how long the scanner stays on the Weather Channel after a transmission ends before
resuming.
Turn [Scroll Control] to select the delay time setting from the following list:
-10 sec
-5 sec
-2 sec
0 sec
1 sec
2 sec
5 sec
10 sec
30 sec
Then press [E / yes / gps] to accept and return to the previous menu.
Set Attenuator
You can attenuate RF reception on the frequency.
On The frequency will be attenuated.
Off The frequency will not be attenuated.
Press [E / yes / gps] to accept the selection and return to the previous menu.
Set Audio AGC
When Audio AGC function is “On”, the scanner judges volume of the signal and changes the volume
automatically.
You can turn “On” or “Off” AGC for Analog audio.
Analog : On / Off
On Audio AGC is on.
Off Audio AGC is off.
Turn [Scroll Control] to focus the cursor on the item. Press [E / yes / gps] to change the setting and press
[Menu] to return to the previous menu.
WX Alt Priority
This setting determines how the scanner treats the Weather Channels in Scan/Hold Mode Search/Hold
Mode and Close Call Mode.
On The scanner checks the Weather Channels every 5 seconds to check for the presence of a 1050 Hz
Weather Alert Tone.
Off The scanner does not check the Weather Channels.
Press [E / yes / gps] to set this setting and return to the previous menu.