Set modulation, Set attenuator, Set lockout – Uniden BCD396XT User Manual

Page 51: Set hold time

Advertising
background image

Friday, November 07, 2008

51

Set Modulation

You can select the modulation from following settings.

Auto* The scanner uses the modulation normal for the frequency’s band.
NFM

The scanner uses Narrowband FM demodulation.

FM

The scanner uses FM demodulation.

Press [E / yes / gps] to accept the entry and return to the previous menu.

*If the system type is “MOT”,”LT” or “EDCS SCAT”, when the default modulation of the frequency in Band
Defaults
is not FM or NFM, the scanner will operate as FM.

Set Attenuator

You can attenuate RF reception on the frequency.

On

The frequency will be attenuated.

Off

The frequency will not be attenuated.

Press [E / yes / gps] to accept the selection and return to the previous menu.

Set Lockout

This option allows you to lock or unlock the current system. When the system is locked out, the scanner
does not check it.

Unlocked

The system is unlocked.

Temporary L/O

The system is temporarily locked out.

Lockout

The system is locked out.

Press [E / yes / gps] to accept the selection and return to the previous menu.

Set Hold Time

In Trunked Systems, this setting is applied only when a Control Channel can be received.

If no Control Channel can be received, the scanner goes to the next system immediately.

You change this setting from 0 to 255 seconds by pressing the number keys.

Press [E / yes / gps] to accept the entry and return to the previous menu.

If you enter over “255” for the Hold Time, the scanner prompts "Out of Range" and "Set Max? (Y/N)".
When [E / yes / gps] is pushed, maximum value 255 will be set.

It returns to the edit state, if you press [. / no / pri].

Advertising