Dish Network Solo ViP 411 - Manual (Page 101)

Connections
91
Connecting to the TV
Standard-Definition Connections
1
Connect the receiver to the TV using one of the following connections.
Note: Connecting your TV directly to the audio/video outputs of your receiver will assure a
more vivid picture and enhance your viewing enjoyment.
• A UDIO /V IDEO connection (RCA-type composite connection)
• S-V IDEO and L EFT /R IGHT A UDIO
• TV S ET O UT
2
If using the TV S ET O UT connection, peel off the white sticker and attach it to the cable
close to where it connects to the TV S ET O UT connection on the back of the receiver. The
sticker is in the front cover of this guide.
3
Turn on the TV and receiver to make sure you have a picture.
• If using the TV S ET O UT connection, you’ll need to set your TV to either channel 3 or 4.
This output channel can be changed in the receiver’s menus by pressing MENU on
the remote control, selecting System Setup, Installation, then Modulator Setup.
The default output is channel 3.
• If using the S-V IDEO or A UDIO /V IDEO connections, you’ll need to set your TV to a video
input or source. Refer to your TV’s user guide for more information.
4
Turn up the volume on the TV to make sure you have audio.