Dish Network Solo ViP 411 - Manual (Page 78)

Chapter 9
68
Operating Other Devices
Controlling a Tuner or Amplifier
Use the following remote control buttons to control a tuner, amplifier, or audio receiver.
When the remote control is set up, press the AUX mode button to set the remote to AUX
mode. The AUX mode button stays lit for two seconds to show you’ve set the remote to
AUX mode. Make sure to keep the remote in AUX mode to use the following buttons.
Switching Between TV and Tuner/Amplifier Volume Control
When the remote control is setup to operate your TV, the VOLUME and MUTE buttons will
adjust your TV volume. To use the remote to adjust the volume of a remote-controllable
audio receiver or amplifier instead of adjusting the TV’s volume, use the steps To Use a
Tuner or Amplifier’s Volume Control, below. To switch back to control the TV’s volume, use
the steps To Use the TV’s Volume Control.