Mproving, Eceiver, Ontrol – Dish Network Solo ViP 411 User Manual
Page 66: Chapter 9, Making the remote work with the receiver, Changing the remote control address
Chapter 9
56
Improving Receiver Control
I
MPROVING
R
ECEIVER
C
ONTROL
These instructions help you improve your remote control settings to best operate your dish
antenna.
Making the Remote Work with the Receiver
These instructions configure your remote.
1
Turn your receiver and TV on, and press SYSTEM INFO on the front of the receiver.
2
Confirm that you see the System Info screen.
3
Press RECORD on your remote. The receiver then matches the remote’s address.
4
Confirm that your remote operates your receiver by pressing remote buttons. If this is not
working, go back to step 3.
Changing the Remote Control Address
Because UHF signals travel long distances and go through walls, a neighbor’s remote
may control your receiver by mistake. To prevent this, you can change the remote
address.
1
Turn your receiver
and TV on, and press
SYSTEM INFO on the
front of the receiver
Confirm that
you see the
System Info screen
Press RECORD.
The receiver then
matches the
remote’s address
Confirm that your
remote operates your
receiver by pressing
remote buttons