Remote control setup, Turning limited mode on and off, Sat auto-tune – Dish Network Solo ViP 411 User Manual
Page 69
Remote Control Setup
59
Operating Other Devices
Turning Limited Mode On and Off
1
Press and hold the correct mode button (for example, TV) until all of the mode buttons
light. Release the mode button.
2
Press:
•
PAGE UP to turn Limited Mode on.
•
PAGE DOWN to turn Limited Mode off.
3
Press POUND (#).
SAT Auto-Tune
The SAT Auto-Tune feature, which is enabled by default, sends the correct TV channel for
viewing satellite TV when you select the SAT mode button on the remote control.
SAT Auto-Tune can only send a channel to the TV, not an input. Because of this, SAT
Auto-Tune is most useful for TV2. If used for TV1, channel 3 or 4 should be programmed
using the steps under Setting SAT Auto-Tune Channel. The TV channel programmed for
SAT Auto-Tune is also the channel that will be sent to the TV if the RECOVER button is
used. The steps in Setting SAT Auto-Tune Channel can also be used in VCR mode to
program the channel sent to a VCR during the Recover process.
For SAT Auto-Tune to function correctly, the correct channel for the installation must be
programmed into the remote using the steps under Setting SAT Auto-Tune Channel.
Press POUND (#)
Press and hold the
correct Mode button until
all Mode buttons light.
Release Mode button
Press PAGE UP to
turn Limited Mode on.
Press PAGE DOWN to
turn Limited Mode off