Chapter 9, Programming to control a second dish antenna – Dish Network Solo ViP 411 User Manual
Page 80
Chapter 9
70
Operating Other Devices
Programming to Control a Second Dish Antenna
If you have a second DISH Network antenna installed, you can use this remote in AUX
mode to operate your other receiver in addition to operating the first receiver. When you
program the remote to operate the other receiver, the remote sends out IR signals to the
receiver so the line of sight to the second dish antenna must be unobstructed. You can
program the remote control to operate any other DISH Network antenna, except where
UHF is used, such as TV2 on DISH Network antennas.
1
Turn on the other receiver and display the System Info screen as described in that user’s
guide.
Write down the remote control address:
2
Press and hold AUX until all the other mode buttons light up, and then let go of the button.
AUX flashes.
3
Press the 3 button.
4
Use the NUMBER PAD to enter the address you wrote in step 1.
5
Press POUND (#). AUX blinks three times.
6
Press RECORD to ensure the address in the remote matches the address on the receiver.
1
2
3
5
4
Press and hold the
AUX Mode button until all
Mode buttons light up
(AUX flashes)
Display System Info
screen and note the
Remote Control Address
Press the
3 button
AUX
Enter remote
address from
Step 1
Press POUND
(AUX flashes
three times)
6
Press
RECORD