Dish Network Solo ViP 411 - Manual (Page 76)

Chapter 9
66
Operating Other Devices
3
On the DISH Network remote, press and hold the mode button for your equipment for
about three seconds until all the mode buttons light up, and then release it. Your selected
mode button blinks.
4
Point the front of the original device’s remote to face the small square (IR window) on the
front, left-hand side of your DISH Network remote, as shown above.
5
On your DISH Network remote, press the button you want to teach.
6
On the original device’s remote control, press and hold the button you want learned. If the
DISH Network remote learns the command, the mode light blinks off and then back on. If
the mode light blinks three times or remains lit, the DISH Network remote did not learn the
command. You may need to press the button on the original remote several times for the
DISH Network remote to learn the command.
7
After a button has learned a command successfully, repeat steps 6 and 7 until all
commands you want have been learned.
8
Press one of the mode buttons on the DISH Network remote to end the learning
sequence. This saves all the commands for that mode and exits learning to return to
normal remote control operation.
To cancel learning, do not press any buttons on either remote control for at least 30
seconds. The DISH Network remote control times out and returns to normal operations.
Note: If the remote control batteries are too low for learning, all the mode buttons blink
quickly eight times, learning ends without saving learned commands, and the remote
returns to normal operation. Change the batteries.
Note: No learned commands are saved if the DISH Network remote controls times out
before completion.