Remote control setup, Enabling and disabling sat auto-tune, Removing sat auto-tune channel – Dish Network Solo ViP 411 User Manual
Page 71
Advertising
Remote Control Setup
61
Operating Other Devices
Enabling and Disabling SAT Auto-Tune
Note: SAT Auto-Tune is enabled by default; however, the channel must be set (see
Setting SAT Auto-Tune Channel).
1
Press and hold SAT for three seconds until all four Mode buttons are lit.
2
Press STAR (*).
3
Press VOLUME UP to enable SAT Auto-Tune or VOLUME DOWN to disable.
4
Press POUND (#).
Removing SAT Auto-Tune Channel
1
Press and hold TV until it stays lit.
2
Press STAR (*).
3
Enter 00 or 000.
4
Press POUND (#).
Advertising