Chapter 9, Setting auto-tune for vcr, Removing auto-tune for vcr – Dish Network Solo ViP 411 User Manual
Page 72
Chapter 9
62
Operating Other Devices
Setting Auto-Tune for VCR
You can set Auto-Tune for your VCR. Auto-Tune allows you to return to the channel for
your DVD/VCR output when you accidentally change the channel or video input.
1
Make sure the remote control operates your DVD/VCR.
2
Press and hold DVD for three seconds until all four Mode buttons are lit.
3
Press STAR (*).
4
Enter the channel used for viewing (up to three digits in range of 002 to 125), for example
channel “003” or “004.”
5
Press POUND (#). The Mode button flashes three times to indicate programming was
successful.
Removing Auto-Tune for VCR
If you want to remove Auto-Tune for your VCR, follow these steps.
1
Press and hold DVD until it stays lit.
2
Press STAR (*).
3
Enter 00 or 000.
4
Press POUND (#).