Dish Network Solo ViP 411 - Manual (Page 114)

104
Troubleshooting Tables
Reference
015
You may have just plugged in the
receiver and it is acquiring the
satellite signal or the receiver may
have temporarily lost the signal.
• Wait a few minutes to see if the message goes away.
Make sure that all required cables are in place, and check
that all cable connections are tight and dry (for outdoor
cables).
• Make sure that the satellite dish has a clear line of sight to
the satellite. Check whether branches or leaves have
grown into the line of sight.
• Check that the Signal Strength bar in the Point Dish
screen is green and displays the word Locked. If not,
contact your installer to re-aim the satellite dish.
018
The receiver may not be
connected to an active telephone
line or broadband Internet
connection.
• You must connect the receiver to an active telephone
connection at all times. If you install two or more receivers,
you must connect each receiver to an active telephone
connection at all times.
• Call the Customer Service Center at 1-800-894-9131 for
help checking the credit limit and/or to get authorization to
make a purchase.
022
The receiver may not have
received authorization for
programming yet. The satellite
dish may have moved so that it is
no longer picking up the satellite
signal. The cable connections
may have loosened or have
moisture inside. There may be an
interruption of the satellite signal.
• If you have authorized the receiver, wait a few minutes to
see if the message is removed. Make sure that all required
cables are in place, and check that all cable connections
are tight and dry (for outdoor cables).
• Make sure that the satellite dish has a clear line of sight to
the satellite. Check whether branches or leaves have
grown into the line of sight.
• Check that the Signal Strength bar in the Point Dish
screen is green and displays the word Locked. If not,
contact your installer to re-aim the satellite dish. If you
have not authorized the receiver, call the Customer
Service Center at 1-800-894-9131 for help.
026
The receiver may have
temporarily lost the satellite signal.
• Wait a few minutes to see if the message is removed.
Make sure that all required cables are in place, and check
that all cable connections are tight and dry (for outdoor
cables).
• Make sure that the satellite dish has a clear line of sight to
the satellite. Check whether branches or leaves have
grown into the line of sight.
• Check that the Signal Strength bar in the Point Dish
screen is green and displays the word Locked. If not,
contact your installer to re-aim the satellite dish.
028
The receiver may need to get new
software before you can use it to
order Pay-Per-View programs.
Turn the receiver off. Doing this allows the receiver to
download new software via the satellite signal. The
download may take several minutes; do not disturb or unplug
the receiver during this time. When the download is done,
you will be able to use it to order Pay-Per-View programs.
059
You may have tried to close an
installation menu without having
done the Check Switch test.
If your setup includes a multi-dish switch, you must run the
Check Switch test.
060
You may have aimed the satellite
dish at one satellite, but selected
the option for another satellite on
the Point Dish screen.
• Make sure that you have selected the option for the right
satellite on the Point Dish screen.
• Make sure that the cable(s) for the satellite you have
selected are connected to the LNBF that receives signals
from that satellite. Re-aim the satellite dish at the right
satellite.
061
The receiver is downloading
current software.
It is very important for the receiver to get the latest software
to function properly. The download may take several
minutes. Do not disturb or unplug the receiver during this
time.
Message
Number
Possible Reason What to Do