Operating tips for heater and air conditioner – Subaru 2008 Forester 2.5X User Manual

Page 154

Advertising
background image

Black plate (159,1)

北米Model "A8130BE-B" EDITED: 2007/ 7/ 25

Pressing the button cancels the AUTO
mode. SUBARU recommends using the
AUTO position.

NOTE

The air conditioner

’s compressor does

not operate with an outside tempera-
ture of 32

8F (08C) or lower.

& Temperature sensors

1)

Interior air temperature sensor

2)

Solar sensor

The automatic climate control system
employs several sensors. These sensors
are delicate. If they are not treated
properly and become damaged, the sys-
tem may not be able to control the interior
temperature correctly. To avoid damaging

the sensors, observe the following pre-
cautions:
– Do not subject the sensors to impact.

– Keep water away from the sensors.

– Do not cover the sensors.

The sensors are located as follows:
– Solar sensor: beside the windshield
defroster grille.
– Interior air temperature sensor: near
the ignition switch.
– Outside temperature sensor: behind
the front grille.

Operating tips for heater and
air conditioner

& Cleaning ventilation grille

Always keep the front ventilation inlet grille
free of snow, leaves, or other obstructions
to ensure efficient heating and defrosting.
Since the condenser is located in front of
the radiator, this area should be kept clean
because cooling performance is impaired
by any accumulation of insects and leaves
on the condenser.

& Efficient cooling after parking

in direct sunlight

After parking in direct sunlight, drive with
the windows open for a few minutes to
allow outside air to circulate into the

Climate control

4-11

– CONTINUED –

4

Advertising
This manual is related to the following products: