Subaru 2008 Forester 2.5X - Manual (Page 97)

Black plate (98,1)
北米Model "A8130BE-B" EDITED: 2007/ 7/ 25
2-8
Keys and doors
you close the door, it will automatically
lock.
NOTE
If the “ ” button is pressed for 2
seconds or longer, the panic alarm will
sound. When locking the doors in
normal circumstances, press the
“ ”
button for less than 2 seconds. For
details on the panic alarm, refer to
“Sounding a panic alarm”.
& Unlocking the doors
Briefly press the “ ” button (for less than
2 seconds) to unlock the driver ’s door. An
electronic chirp will sound twice and the
turn signal lights will flash twice. To unlock
all other doors and the rear gate, briefly
press the
“ ” button a second time within
5 seconds.
NOTE
If the interval between the first and
second presses of the
“ ” button (for
unlocking of all of the doors and the
rear gate) is extremely short, the sys-
tem may not respond.
& Illuminated entry
The interior (dome and cargo area) light
will illuminate when the
“ ” button is
pressed. This light stay illuminated for
approximately 30 seconds if any of the
doors or the rear gate is not opened.
If the
“ ” button is pressed before 30
seconds have elapsed, this light will go
out.
To activate this function, set the following
interior light switches to the indicated
positions:
Dome light: Middle position
Cargo area light: DOOR position
& Vehicle finder function
Use this function to find your vehicle
parked among many vehicles in a large
parking lot. Provided you are within 30 feet
(10 meters) of the vehicle, pressing the
“ ”
button 3 times in a 5-second period will
cause your vehicle
’s horn to sound once
and its turn signal lights to flash 3 times.
NOTE
If the interval between presses is too
short when you press the
“ ” button 3
times, the system may not respond to
the signals from the remote transmitter.
& Sounding a panic alarm
To activate the alarm, keep the “ ” button
pressed for more than 2 seconds.
The horn will sound and the turn signal
lights will flash.
To deactivate it, press any button on the
remote transmitter. Unless a button on the
remote is pressed, the alarm will be
deactivated after approximately 30 sec-
onds.
& Selecting audible signal op-
eration
Using an electronic chirp, the system will
give you an audible signal when the doors
lock and unlock. If desired, you may turn
the audible signal off.
Do the following to deactivate the audible
signal. You can also use the same steps
to restore the function.
1. Sit in the driver
’s seat and shut all
doors and the rear gate.
2. Open the driver
’s door, then remove
the key from the ignition switch.
3. Hold down the
“UNLOCK” side of the
power door locking switch.
4. While holding down the
“UNLOCK”
side of the power door locking switch,
insert the key into the ignition switch and
remove it again at least 6 times within 10
seconds after Step 3.