Subaru 2008 Forester 2.5X - Manual (Page 295)

Black plate (304,1)
北米Model "A8130BE-B" EDITED: 2007/ 7/ 25
11-14
Maintenance and service
Non-turbo models
1)
Filler neck
2) Fill up to this level
Turbo models
1)
Filler neck
2) Fill up to this level
5. Slowly pour the coolant and fill up to
just below the filler neck, allowing enough
room to add genuine Subaru cooling
system conditioner in the radiator. Add
genuine Subaru cooling system condi-
tioner until the coolant level reaches the
filler neck. Do not pour the coolant too
quickly, as this may lead to insufficient air
bleeding and trapped air in the system.
Guideline of coolant quantity (including
coolant in reservoir tank):
Non-turbo models:
MT: 7.3 US qt (6.9 liters, 6.1 Imp qt)
AT: 7.2 US qt (6.8 liters, 6.0 Imp qt)
Turbo models:
MT: 7.8 US qt (7.4 liters, 6.5 Imp qt)
AT: 7.7 US qt (7.3 liters, 6.4 Imp qt)
1) “FULL” level mark
2) “LOW” level mark
6. Pour the coolant and fill to the reser-
voir tank
’s “FULL” level mark.
CAUTION
. Be careful not to spill engine
coolant when adding it. If coolant
touches the exhaust pipe, it may
cause a bad smell, smoke, and/or
a fire. If engine coolant gets on
the exhaust pipe, be sure to wipe
it off.
. Do not splash the engine coolant
over painted parts. The alcohol
contained in the engine coolant
may damage the paint surface.