Subaru 2008 Forester 2.5X - Manual (Page 181)

Black plate (188,1)
北米Model "A8130BE-B" EDITED: 2007/ 7/ 25
5-24
Audio
CAUTION
. Do not attempt to insert two or
more discs into the slot at a time.
Doing so can cause mechanical
damage to the CD changer.
. Use only music CDs identified by
a mark.
. Do not use CDs listed in the
following which could cause da-
mage to the CD player.
– 3 inch (8 cm) compact disc
– Any disc with a peel-off or seal
on it
– Bent disc
– Cleaning disc
– CD accessory (e.g., 3 inch (8
cm) disc adapter)
. Do not insert or remove any disc
when the automatic transmission
selector lever is in the park
position; the selector lever in that
position can interfere with disc
insertion or removal, causing
scratches on the disc surface
(for AT vehicles).
! To insert a disc
1. Press one of the disc select buttons (3)
(numbered from 1 to 6) for which the disc
indicator light (2) is
“OFF”.
The disc indicator lights are located
directly above the corresponding disc
select buttons.
2. The indicator will begin blinking. The
blinking will last for 15 seconds.
During this period, insert a desired disc,
and the disc will begin to play. (If any disc
is not inserted during this period, the
“Disc
slot ” (1) door will close. Repeat Step 1.)
Be sure to hold a disc with the label side
(the side where titles are printed) up.
3. To insert another disc, repeat Steps 1
and 2 choosing a different disc select
button.
! To insert six discs at a time
1. Press and hold the disc select button
number 1 until all disc indicators begin
blinking (approximately 1.5 seconds).
2. The indicators will blink for 15 sec-
onds. During this period, insert desired six
discs.
3. When all discs are loaded, the first
disc will begin to play. (If no disc is
inserted within this 15 seconds, the entire
disc load sequence will be canceled.)
! To remove a disc
1. Press the desired one of the disc
select buttons (3) (numbered from 1 to 6)
for which the disc indicator light is on.
2. Press the eject button (4). The se-
lected disc will be ejected and the
indicator light will begin blinking.
3. To remove another disc, repeat Steps
1 and 2 choosing a different disc select
button.
(To remove discs when the ignition switch
is in the
“Lock” position, press the eject
button, and the first disc will be ejected.
Press the eject button again, and the next
disc will be ejected and so on. At this time,
the disc select buttons are disabled.)
! To remove all discs at one time
1. Press and hold the eject button (4)
until all
“Disc” indicators begin blinking
(approximately 1.5 seconds), and the first
disc will be ejected.
2. When the disc is removed, the next
one will be ejected, and so on.
! To replace a playing disc with
another
Simply press the desired one of disc
select buttons (3) (numbered from 1 to 6)
or press the disc select button on the radio
unit to select the desired disc, and the disc