Subaru 2008 Forester 2.5X - Manual (Page 161)

Black plate (168,1)
北米Model "A8130BE-B" EDITED: 2007/ 7/ 25
5-4
Audio
Type A audio set (if equipped)
The radio will operate only when the ignition switch is in the “Acc” or “ON” position.
& Radio operation
(1) Power switch, Volume control, Tone/
Fader/Balance control dial
(2) BAND button
(3) Tuning buttons
(4) Preset buttons
(5) AUDIO button
(6) SCAN button
! Power switch and volume/bass/tre-
ble/fader/balance control (PWR/
VOL)
The dial (1) is used for both power (ON/
OFF) and volume control. The radio is
turned ON and OFF by pushing the dial
and the volume is controlled by turning the
dial.
! Tone and balance control
The
“VOLUME” control knob normally
function as volume control. This knob
become a control for Treble, Bass, Fader
or Balance when you select the appro-
priate audio mode.
Choose desired volume level for each
mode by turning the
“VOLUME” control
knob. The control function returns to
volume control mode after approximately
5 seconds.
To change control modes: Each brief
press of the
“AUDIO” button changes
control modes in the following sequence
starting from volume control mode. (When
the radio is first turned on, the control