Applied Motion STAC6-C - Manual (Page 4)

4
STAC6 Hardware manual 920-0029 Rev. C
5/2/2012
Safety Instructions
Only qualified personnel are permitted to transport, assemble, commission, and maintain
this equipment. Properly qualified personnel are persons who are familiar with the trans-
port, assembly, installation, commissioning and operation of motors, and who have the
appropriate qualifications for their jobs. The qualified personnel must know and observe the
following standards and regulations:
IEC 364 resp. CENELEC HD 384 or DIN VDE 0100
IEC report 664 or DIN VDE 0110
National regulations for safety and accident prevention or VBG 4
To minimize the risk of potential safety problems, you should follow all applicable local and national codes
that regulate the installation and operation of your equipment. These codes vary from area to area and it is
your responsibility to determine which codes should be followed, and to verify that the equipment, installa-
tion, and operation are in compliance with the latest revision of these codes.
Equipment damage or serious injury to personnel can result from the failure to follow all applicable codes
and standards. We do not guarantee the products described in this publication are suitable for your particu-
lar application, nor do we assume any responsibility for your product design, installation, or operation.
• Read all available documentation before assembly and commissioning. Incorrect handling of products
in this manual can result in injury and damage to persons and machinery. Strictly adhere to the technical
information on the installation requirements.
• It is vital to ensure that all system components are connected to earth ground. Electrical safety is impos-
sible without a low-resistance earth connection.
• The STAC6 contains electrostatically sensitive components that can be damaged by incorrect handling.
Discharge yourself before touching the product. Avoid contact with high insulating materials (artificial
fabrics, plastic film, etc.). Place the product on a conductive surface.
• During operation keep all covers and cabinet doors shut. Otherwise, there are deadly hazards that could
possibility cause severe damage to health or the product.
• In operation, depending on the degree of enclosure protection, the product can have bare components that
are live or have hot surfaces. Control and power cables can carry a high voltage even when the motor is not
rotating.