KLING & FREITAG K&F SEQUENZA 10 W - Manual (Page 23)

User's manual K&F SEQUENZA 10 N/W/B & Flying Frame
KLING & FREITAG GMBH © 2014 Version Version 6.1 Page 23 of 70
10.
Caution
Tipping of the flying frame with speakers can result in injuries. To prevent the frame
from tipping forward with the first speaker, always connect the speakers to one another
first before connecting the flying frame.
To prevent the frame from tipping forward with the first speaker, let the spring bolts of
the first two speakers snap into place before connecting the flying frame.
To do so, you must position the spring bolt of the second speaker horizontally and you
may need to tilt the speaker slightly until the spring bolt snaps into place.
11.
Place the frame in front of the
top speaker so that all joint plates
(1) protrude into the frame, then
connect them using the Quick
Release Pins (2).
12.
Insert the rear joint plate (1) of the
top speaker between the drill holes
for the desired angle, and secure it
with the Quick Release Pin (2).
The tilt angle of the speakers
relative to the flying frame is
determined by the simulation
software CON:SEQUENZA.
To fly the top speaker parallel (0°)
to the flying frame, use the drill
hole 'Flying 0°' (see illustration).
To tilt the top speaker upwards by
+3°, use the 'Flying +3°' hole (see
illustration).
13. Wire the speakers. Further information in chapter 'Connection' on page 44.
Detailed information for connecting the speakers and configuring the K&F system
amplifier TOPAS or the K&F SystemRack is in the hardware manuals.
14. Proceed as described in chapter Lifting the Array as of page 28.