KLING & FREITAG K&F SEQUENZA 10 W - Manual (Page 33)

User's manual K&F SEQUENZA 10 N/W/B & Flying Frame
KLING & FREITAG GMBH © 2014 Version Version 6.1 Page 33 of 70
11.1 Disassembly of arrays with SEQUENZA 10 N/W exceeding a
Length of 5m
1. Replace each transport cover when the speakers are hanging at working level.
2.
Just before the bottom speaker
touches the ground, two people
must grab hold of the speaker at
the recessed handles.
Release the rear Quick Release Pins
(1) first and catch the speaker while
it is swinging down by holding it at
the recessed handles.
Then release the lower front Quick
Release Pins of the next highest
speaker (2) and remove the lowest
speaker.
1
2
2
3. Disassemble as many speakers in this manner until the array only has a remaining
length of max. 5m (For arrays only having SEQUENZA 10 N/W systems, this corresponds
to 16 speakers). Then proceed as described in sub-section Disassembly of arrays with
SEQUENZA 10 N/W and a maximum Length of 5m.
11.2 Disassembly of arrays with SEQUENZA 10 N/W and a
maximum Length of 5m
1. When all four castors of the SEQUENZA 10 N/W speaker touch the ground, pull the
spring bolt until it comes free.
During lowering, starting with the lowest speaker, there is a point for each speaker at
which its rear connection is force-free. Pull the spring bolts out at this moment.
2. Prepare the SEQUENZA 10 system for transport:
• After you have completely lowered the array, release all Quick Release Pins and push
the speakers apart.
• With the SEQUENZA 10 N/W systems, set the Quick Release Pins of the rear
connecting brackets to the 0° position.
• Push all rear joint plates of the SEQUENZA 10 N/W systems into their park position
so that the spring bolts snap back into place. To put it into the park position, use the
drill hole that is not completely drilled through in the rear joint plate.
• Pull the front Quick Release Pins and put them into the park position of the speaker
enclosure. If the safety cords on the Quick Release Pins protrude out of the side of
the speaker, turn the Quick Release Pins so that the safety cords are in the grooves.
This way you can protect the safety cords from transport damage.
• Push the front joint plates into the speaker.
• Dismantle all other used components so that they are not exposed and get damaged
during transport.