KLING & FREITAG K&F SEQUENZA 10 W - Manual (Page 29)

User's manual K&F SEQUENZA 10 N/W/B & Flying Frame
KLING & FREITAG GMBH © 2014 Version Version 6.1 Page 29 of 70
4.
Verify that every spring bolt locks
into place.
When the spring bolts snap into
place, they make a clearly audible
noise and protrude out of the drill
hole on the opposite side.
5. Check that the spring bolts protrude at least 0.5 mm out of the drill holes at the entire
circumference (A).
During lifting, the spring bolts snap into place successively from the flying frame
downwards.
Warning
If the spring bolts do not properly snap into place, do not hoist the array any further
until you have corrected the error.
6. When the first speakers are at working height, remove the front transport covers.
7. When the first SEQUENZA 10 N/W speakers are at working height, you can attach the
protective weather covers for this speaker model, if necessary.
For outside uses, these optional protective weather covers with hook-and-loop fastener
serve as rain protection for the rear flying mechanics and the cable connections.
8. Lift the array evenly and slowly into its operating position so that it cannot swing out
during lifting, then secure it. In doing this, make sure that chain hoists and lifting
accessories do not get caught. Make sure that the speaker cables do not get crimped or
get caught.