KLING & FREITAG K&F SEQUENZA 10 W - Manual (Page 28)

User's manual K&F SEQUENZA 10 N/W/B & Flying Frame
KLING & FREITAG GMBH © 2014 Version Version 6.1 Page 28 of 70
6. Wire the speakers. Further information in chapter 'Connection' on page 44. Detailed
information for connecting the speakers and configuring the K&F system amplifier TOPAS
or the K&F SystemRack is in the hardware manuals. SEQUENZA 10
7. Proceed as described in chapter Lifting the Array as of page 28.
10.2 Lifting the Array
Warning
See the instructions in chapter 'Safety Instructions' from page 11 and in the corresponding
sub-section 'Safety Instructions for Flown Setup' from page 11.
10.2.1 Arrays with SEQUENZA 10 B
This description is valid for a maximum of 12 SEQUENZA 10 B systems connected to one
another. More than 12 SEQUENZA 10 B systems connected to one another may not be
flown.
1. Attach a certified 3.25 ton shackle for every speaker used.
Secure the shackles against self-loosening (i.e. split pin).
2. Hook the load hook of the hoist chain (i.e. of the hoist motor) into the load adapter's
shackle and begin to lift the array carefully.
3. When the first speakers are at working height, remove the front transport covers.
4. Lift the array evenly and slowly into its operating position so that it cannot swing out
during lifting, then secure it. In doing this, make sure that chain hoists and lifting
accessories do not get caught. Make sure that the speaker cables do not get crimped or
get caught.
10.2.2 Arrays with SEQUENZA 10 N/W and 5m maximal Length
This description is valid for arrays that only consist of SEQUENZA 10 N/W systems as well as
for mixed arrays of SEQUENZA 10 N/W and SEQUENZA 10 B whose total length does not
exceed 5m. (An array with 16 x SEQUENZA 10 N/W corresponds to a length of 5m).
1. Attach a certified 3.25 ton shackle for every speaker used.
Secure the shackles against self-loosening (i.e. split pin).
2.
Verify that every spring bolt of
the SEQUENZA 10 N/W are in a
horizontal position (closed), so
that they can lock into place when
lifting the array.
3. Hook the load hook of the hoist chain (i.e. of the hoist motor) into the load adapter's
shackle and begin to lift the array carefully.