Paxton Superchargers GM 8.1 HD Truck/SUV - Manual (Page 49)

20-1
P/N: 4809642
©2004 Paxton Automotive
All Rights Reserved, Intl. Copr. Secured
28SEP04(4809642 v1.2)8.1GMTruck
20.1 FINAL ASSEMBLY AND CHECK
A. Reconnect the battery.
B. If your vehicle has gone over 30,000 miles
since its last spark plug change, you will
need to change the spark plugs now before
test driving the vehicle.
C. Check all fittings, nuts, bolts and clamps for
tightness. Pay particular attention to oil and
fuel lines around moving parts, sharp edges
and exhaust system parts. Make sure all
wires and lines are properly secured with
clamps or tie wraps.
D. Check all fluid levels, making sure that your
tank(s) is/are filled with 91 octane or higher
fuel before commencing test drive.
E. The plastic engine cover that covers the
upper manifold will need to be modified in
order to reinstall. Trim for best fit.
F. Start engine and allow to idle a few minutes.
G. Recheck to be sure no hoses, wires, etc. are
near exhaust headers or moving parts and
check for any sign of fluid leakage. Recheck
all fluid levels.
***SPECIAL NOTE***
Operating the vehicle without ALL the sub-
assemblies completely and properly installed
may cause FAILURE OF MAJOR COMPO-
NENTS.
H. Test drive the vehicle.
I. Read the Street Supercharger System
Owner's Manual and RETURN THE
Warranty REGISTRATION FORM within
thirty (30) days of purchasing your super-
charger system to qualify for the 3 year lim-
ited warranty.
Section 20
FINAL ASSEMBLY AND CHECK