Xtramus NuApps-2544-RM V1.3 - Manual (Page 15)

15
Starting NuServer
If an error message window pops up and says
“Detecting NuServer System Fail”, please close
NuApps-2544-RM and NuServer, and start again.
After starting NuApps-2544-RM, a Select Config window will pop up. You have to reserve ports on
module cards before performing tests with NuApps-2544-RM. Please follow the steps down below and
make the proper configurations for NuApps-2544-RM.
Port Reserving
As mentioned above, you have to reserve ports on module cards before performing tests with
NuApps-2544-RM. You can do so by either Open an Existing Configuration or by Create a New
Configuration.
If you have a previously saved configuration file
stored in your PC, you can load it and apply all the
setting you’ve made by choosing “Open an
Existing Configuration” from the Select Config
pop-up window.
Configuration files are saved in the format of
“＊.xml”, and are named with Tester Name, DUT
Name, and the date/time when the files are
created.
If the module card information contained in the
configuration file you’ve loaded from your PC has
more module cards than your current amount of
module cards, a warning message will pop up,
showing that “Available ports are not enough”.
If this happens, please click the OK button, and
choose Create a New Configuration from the
Select Config window instead.
E-mail: [email protected]
Website: www.Xtramus.com
XTRAMUS TECHNOLOGIES ®