Xtramus NuApps-2544-RM V1.3 - Manual (Page 3)

3
E-mail: [email protected]
Website: www.Xtramus.com
XTRAMUS TECHNOLOGIES ®
Revision History
Date Version Software History
Sept, 2010 1.0 First draft version
2010/10/06 1.1
1. Change Revision History date format.
2. Add NuApps-2544-RM hardware installation figure on
page 12.
2011/03/23 1.2 v1.0b013
1. Change water mark to Preliminary.
2. Change NuApps-254-RM Main Window picture on
page 18.
3. Add System Requirement on page 22.
4. Change Test Config picture on page 24 and 26.
5. Change Control Buttons/Test Running Status Icon
pictures on page 27.
6. Change Test Configuration main window picture on
page 31.
7. Add Pairing/Assigning Test Ports chapter on page 32.
8. Add Software Version on Revision History
2011/05/16 1.3 v1.1b001
1. Page 5, adding XM-RM Module card requirement table,
and updating NuApps-2544-RM installing
requirements.
2. Page 6, add note messages regarding to install
NuApps-2544-RM.
3. Page 15, adding “Available Ports are not enough” info.
4. Page 21, correcting descriptions about “Save/Save as”.
5. Page 23, removing “USB” from Reconnect section.
6. Page 25, changing figure for System Info.
7. Page 26, changing figure for Test Config.
8. Page 31, changing figure for Test Config.
9. Page 32, changing figure.
10. Page 39, changing figure for Throughput, and adding
descriptions about “Delay Time after Learning.”
11. Page 41, changing figure for Latency, and adding
descriptions about “Delay Time after Learning.”
12. Page 43, changing figure for Packet Loss, and adding
descriptions about “Delay Time after Learning.”
13. Page 45, changing figure for Back to Back, and adding
descriptions about “Delay Time after Learning.”
14. Page 49, adding more figures showing test result charts
for different pairs of ports. Also, changing the test report
file format to “xls”.
2011/06/23 1.3 v1.1b003
1. Apply new user manual template.
2. Remove Preliminary watermark.
3. Page 5 and Page 12, changing NuApps-2544-RM logo.