American Time Wireless Remote Transmitter - Manual (Page 11)

11
© American Time
Wireless Remote Transmitter Installation Manual
Glossary
Appendix
Troubleshooting
Clock
Installation
Transmitter and
System Setup
Intr
oduction
System Setup
5. Click on the Ethernet Tab and verify valid Time Server Addresses or enter new ones recorded in Ethernet Configurations
section on page 8.
6. This step is optional. If you would like to disable DHCP and enter a static IP address, uncheck the DHCP box. Enter the Unit IP
Address, Subnet Mask and Gateway IP assigned from your Network Administrator and recorded in the Ethernet Configuration section
on page 9. The Update button must be pressed for changes to take effect.
n Note: After changing to a static IP address, close the browser window and then re-open before trying to access the Remote
Transmitter Connect configuration utility. Enter the IP address in the URL field (Figure 5) of the web browser in the following
format: http://xxx.xxx.xxx.xxx/ and press the Enter key.
7. Click on the Set Tab and select the appropriate local time zone from the drop down menu.
Figure 4
Figure 5
Figure 6