Beisler 739-23-1 Program - Manual (Page 15)

4-15
1.6.5 Testing of step motors
This option allows for the testing of the step motors.
CAUTION!
To complete the test programme, the axes must be referenced.
Operating steps
– Insert the setting template into the X-guide of the sewing machine.
– Switch to test mode (see chapter 1.6).
– Select the test programme by means of the “ ” or “ ” key.
– Press the “OK” key.
The following data is displayed:
– Press the “OK” key.
The reference run is started.
After completion of the reference run, the three step motor axes
complete 50 test cycles each.
The control checks whether the reference position has been reached
without step losses. If no step loss has occurred, the display reads as
follows:
If step losses have occurred, the display reads as follows:
The figure before “Err” indicates the axis/axes where a step loss
occurred.
Display Axis
1 X axis
2 Y axis
3 X and Y axes
4 Z axis
5 X and Z axes
6 Y and Z axes
7 X and Y and Z axes
– Press “OK” key.
The system returns to the basic multitest programme.